Yesterday I went to help a guy with a Victron installation:
- 3x Multiplus 48 5000 in 3-phase configuration
- 1x Color Control
- 1x Smart Solar 250 / 100
- 1x 13.8 BYD battery
- 1x 9 KVA 3-phase genset
I've set up the system (multi, mppt and color control and autostart for the genset by low SOC)
First I've found a problem that whith the genset on, the multis read voltage at the input but not charging, just inverting.
We found that rotating 1 input phase solve the problem.
The funny thing is that when the genset is charging, the color control shows it as a AC INPUT, but also as an AC LOAD.
If I stop the genset the loads disappear (also the input)
Is like the genset draws current.
Can someone explain that? It's fixable?
Thanks