I am doupting what to select.
The current standard settings result in a peak of 29,4V, which I thinkk is to much,
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I am doupting what to select.
The current standard settings result in a peak of 29,4V, which I thinkk is to much,
Hi @Harold
I you're seeing this 'peak' as an instantaneous reading (a 'spike'), best ignored.
The stock Victron algorithms for Pb batts would normally show (for 24V batts), 28.8V Abs and 27.6V float. In practice, temp compensation will affect that too, and determine what is actually applied.
It depends what you're doing with the batts, but you could reduce the V settings as you see fit. The standard algorithm you start with to do that will lose it's 'title', but will act the same, just target different V's.
What is the application? You don't mention solar, so maybe you could go with much less V..
Thanks @JohnC
The system is on a boat, batterys are used for 230V system and starting etc.
Charging by alternator, Qutaro and in the summer solar MPPT.
My question is about the bettery type selection in the Quatro and/or the Voltage settings.
Harold
It may depend on what Quattro firmware that you're on as to the options available, but just pick one. Maybe a GEL/AGM type, to see what it does. Then try selecting the relevant others in turn, and it should tell you the differences between the old and new as you progress.
If you spend a lot of time on shore power, maybe drop the Absorb setting on the algorithm you settle on down to (say) 28.0V. No point pushing them hard if you don't need a cycling-type charge. Most of the Pb algorithms will even drop to a Storage V level if connected continuously, maybe reviving periodically for a short Abs stir-up.
Away from shore, your alternator and mppt will work to their own settings.
See your batt maker as to what they recommend under your conditions.
Johnson controls (Varta/Bosch) are not that open on "technical" stuff. I've been searching for a long time and there's just no info on charging.
Yeh, a little like buying a car and then finding they can't tell you what grade fuel is recommended. Often 'not that open' could loosely be translated as 'don't know' or 'don't care'.
Victron have been charging Pb batts for a long time, and I find the standard algorithms excellent. I've never changed mine off default, but I would if my application were to change. I'd just drop the V's a little (mainly Abs if I didn't need the daily aggression)..
Additional resources still need to be added for this topic
12 People are following this question.