please can someone advise a compatible generator for multiplus II inverter charger 3kw?
The advise is vague...I want to know DEFINITE generator that will connect to Victron without problems.
Any advice/suggestions?
asked
Which generator should I use for Victron Multiplus II 3kw?
Hi @willowfarm,
I wrote a guide here with advice for selecting a suitable generator for use with a MultiPlus - https://www.victronenergy.com/live/multiplus_faq
Thank you...I have read this. I was looking fort actual brand recommendations from experience.
I know this! i just went through it.
i dont know where you live, so I don’t know what’s available where you are, but use these guidelines.
1. What‘s your budget?
2. Oversize the generator for the total capacity by at least 33%. (I’d go 50%) and use the running output , not the surge output, for that math.
3. Get as clean a power source as you can, meaning use pure sine wave over modified.
4. IMPORTANT: Match the input voltage. If your Multi is 120v, don’t go plugging a 240v generator into it. Be aware charge voltage matters as does plugging into a GFCI outlet on the generator-be ready to go and reset the outlet a lot if there are high-amp draws like motors that kick in regularly..
5. If you‘re looking at a portable, spend the extra $200 or so to do it right. You‘re welcome.
Find one that fits those basics and your integration should be pretty seamless. The Multi is a pretty impressive device.
Todd
About pure sine wave: do you need an inverter generator for that? My takeaway from the Generator FAQ was that inverter generators are problematic.
Mike
were you happy with your choice? did you figure out the teething problems? can you send a link to the genny you got in the end
