If I read correctly, the 24V 3000 has a 12V dc aux output. What is amps continuous and max amp burst on this?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
If I read correctly, the 24V 3000 has a 12V dc aux output. What is amps continuous and max amp burst on this?
Not sure, but i think it is 24vdc output not 12vdc on the Multiplus 24/3000
Yes, that may be right. It seems that way, but the purpose does not make sense. Why 24v output, when all you need to do is tie to battery.
What is purpose to have 24v pass through?
To (trickle) charge a 24V starter battery.
Limited value it would seem to me as I cannot think of any vehicle that uses 24 volt battery to start a starter. But okay. Better would be 12v (as far more common). Best would be a 12v/24v switch. This is something I've seen on another companies. (But if you do -- DO NOT let your engineer cheat and just put a resistor for voltage divider!!!! Make him do it right and use the resistor to 1/2 the frequency so the output is 12v not 24v).
Install a small 24 to 12 VDC down converter if you want to use this function. For me i do not use this port on my Multiplus 24/3000. If i am plugged into shore power and need to charge my RV 12 volt system i would just plug in a trickle charger that has some smart function charging.
Hi Tom,
I installed a MultiPlus 24/3000/70-50 120V in line with my travel trailer's shore power infeed. That is, I wired the shore power infeed through a 30A breaker then connected to the 120V AC input terminals of the inverter/charger with the AC output terminals connected to the trailer’s 30A/120V AC panel.
This method seemed the simplest and least invasive integration with the trailer’s existing AC/DC system. Everything onboard operates the same whether connected to shore power or operating on solar/battery power.
Virtually all RVs have an onboard 12V DC converter/charger installed by the manufacturer to power the 12V systems and to charge the coach batteries when plugged into shore power. In my Jayco, the existing IOTA DLS45 DC Converter (with the optional IQ4 Smart Charge Controller) remains in place (in the space under the fridge) providing 12VDC for onboard systems and smart charging for the 12V battery bank mounted on the reach.
Therefore, no need for a 24V to 12V step-down converter or an additional trickle charger.
Hi
Thought I would jump in and ask, I am using the aux output to change the starter bank had a 5amp blade fuse in it, but it blows that, is a start interupt relay needed or a larger fuse acceptable?
Hi @Jwfrary
A 10A fuse should not be a problem.
Are you going from 24v to a 12v "starter" battery? If that is the case, you probably don't want to do that. You'll need a charger that is capable of running on 24v and charging the right chemistry 12v.
Curious is the "starter" part of the vehicle starter battery system?
Additional resources still need to be added for this topic
15 People are following this question.