This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi Community,
I'm building an e-bike with 36V Lion.
Was wondering if a little mppt 100/20-48, fed by 3x12V 100w panels will cut it?
From what I'm reading Voc of 66 (at normal temp) should be all good?
Secondary question; I'm assuming if I setup controller for 36V battery; then load circuit output is locked to 100ma? Asking; can one nominate output voltages for the load circuit independent of the configured battery voltage?
Thanks
Hi G..
"Was wondering if a little mppt 100/20-48, fed by 3x12v 100w panels will cut it?"
Sounds good. You will have to manually set the controller to 36v battery.
You will have to program your battery charge voltages in as there are no Lion pre-sets.
Do not ever let the PV voltage go over 100v.
"Secondary question; im assuming if I setup controller for 36V battery; then load circuit output it locked to 100ma? Asking; can one nominate output voltages for the load circuit independant of the configured battery voltage?"
Unsure what you are asking.
Unfortunately that 100/20-48 has no 36V option, and perhaps the 48V settings may not stretch as far as necessary? Victron's closest for 36V is the 150/35.
What I meant by the secondary question; I can't see anywhere in the VictronConnect app that allows you to specify the voltage output to the 'Load' circuit independently, so I am assuming it is locked in step with the voltage you specify for the battery.
In the case of specifying 36v or 48v battery configs, my understanding is that the load circuit will supply 36v or 48v respectively, and will not supply 20A, but only 100ma, as it is intended to drive a relay.
In other words, can you specify having a 36v battery, but also specify a 'stepped down' 12v output to the 'load' circuit?
The load output is fixed to the actual voltage of the battery side of the DC bus. There is no step up, or step down DC to DC conversation for that output.
You cannot specify a different load output voltage to battery voltage.
Hi all,
I'm working on a very similar topic and wanted to double check (before I buy) that the Victron 100/20-48V indeed can charge a 36v Lion battery? And an additional question; can this particular setup only function with x3 12V 100 Watt panel's? Or can the 100/20-48V handle a lower input from the panels (say x2 12V 100 Watt panels) and still up the voltage to charge the 36V battery? I am building a solar trailer for my ebike and will most likely be limited to x2 panels max. I have come across the Genasun Boost MPPTs which specifically note that they can boost lower inputs to the desired outputs for battery charging - though I think their versatility is much reduced compared to the Victron products and would prefer the latter if it will work.
Any answers very much appreciated.
Many thanks,
Chris.
