This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Here’s a screenshot
Been working fine until this morning. I changed from 6 panels on 1 string to 5 panels each on 2 strings. It seemed to work this morning for a couple hours and then just stopped. The connections are all good, I checked a handful of them. So weird to work for 2 hours and then stop
I’ve tried
turning off the batteries and back on
2 Quattro 10kws I’ve turned on/off
Restarted cerbo multiple times
Pv combiner box on/off
The fix was to remove all power from the mppt restarting it and it works. Stupid victron! I wish I had ac today
It looks like your PV voltage has exceeded 150v, which for a 150/xx controller must never occur.
That doesn’t make sense… been over 200v the last several days
Are you sure that its a 150/70 and not 250/70? Pretty sure its a 250/70, otherwise there would have been at least a PV voltage warning
58.2V on the battery sounds like the BMS could have stopped the charging, or maybe disconnected the battery
I’ve restarted everything. No CBs are triggered. Not sure what to do
