This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Here’s a screenshot
Been working fine until this morning. I changed from 6 panels on 1 string to 5 panels each on 2 strings. It seemed to work this morning for a couple hours and then just stopped. The connections are all good, I checked a handful of them. So weird to work for 2 hours and then stop
I’ve tried
turning off the batteries and back on
2 Quattro 10kws I’ve turned on/off
Restarted cerbo multiple times
Pv combiner box on/off
The fix was to remove all power from the mppt restarting it and it works. Stupid victron! I wish I had ac today
It looks like your PV voltage has exceeded 150v, which for a 150/xx controller must never occur.
That doesn’t make sense… been over 200v the last several days
Are you sure that its a 150/70 and not 250/70? Pretty sure its a 250/70, otherwise there would have been at least a PV voltage warning
58.2V on the battery sounds like the BMS could have stopped the charging, or maybe disconnected the battery
