Apart from the VE.Bus cabling, which software has to be loaded onto the Multiplus 2 inverters before outputs can actually be connected to each other?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Apart from the VE.Bus cabling, which software has to be loaded onto the Multiplus 2 inverters before outputs can actually be connected to each other?
You would need to make sure they are both running the same firmware. Then, setting them up in parallel can be done via Ve.Bus quick configure. Contact me should you need help, I have a .co.za email account too
Additional resources still need to be added for this topic
9 People are following this question.
Multiplus II 48/3000 PMP482305000 and PMP482305010 parallel compatibility.
how can multiplus 1 be used as charger in combination with a multiplus 2 as master and one gx?
Why - 3 x Multiplus II 48V - High Peak Output Current not Equal to Input Current
Multiplus II PMP482305010 rev 08 and rev 09 parallel compatibility