This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have a Multiplus 5kW 24V connected to Victron LiFePO4 25.6/200Ah Smart batteries with a Victron VE. Bus Battery Management System. The Multiplus has the VE Bus BMS Assistant loaded. The AC detector has also been installed. The battery voltage went low and shut off the inverter and when the generator was started and 230V AC put to the inverter nothing happened. How do I get the system to start up when the generator is ON????
Does any other electrical item work on generater ? If not maybe there is a manual switch to change over from 24v to 240 v . Just a thought .
Did you test if the generator works with the multi before?
Maybe you have to adjust a few settings(AC input voltage range, accepted frequencies).
Hi - Generator works fine however the inverter had been shut down by the BMS with low voltage on the batteries. On starting the generator the inverter seemed to not know it was there!!!
@Derek Hewett did you find a solution to this? Please share. I seem to be running into a similar issue.
Hello, is this problem solved?
@derek, did you run your inverter only with a single 200ah battery?
Best regards Robert
