This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi all
So lately I've noticed while my batteries are recharging in the morning that SOC jumps from 82% to 99% pretty much instantly.
BYD B-Box 10.25 v4.22 firmware
SmartSolar Charger MPPT 250/60 v1.39
|
This has happened the last 3 days in a row...
Any ideas why this may be the case?
Thanks!
Once the target voltage of 56.5V is reached, the battery is considered full, and will reset the SOC.
So that part is normal and expected.
Any other changes in the system to lead to the variance in behaviour?
There have been some adjustments made in default behaviour when managed batteries (like BYD) are detected in Victron systems, though I didn’t know that this had already been rolled out in those firmware’s.
Thanks for the response, Guy.
No, no changes in the system (except my load has gone down, so the system is more likely to reach 100%.)
Wondering if this is also related to the slow drain I see overnight while the load is powered from grid - you can see the SOC going below the min set point in the graphs above - min SOC last night was 60%, previous night was 65%
If the load has gone down is there a chance that the SOC jump corresponds to the energy discharged slowly?
hello,
time to time i have same way of acting on battery charging - same BYD.
Thanks! Do you also see a slow discharge at night while there's no load on the battery? (Looks like it from your picture)
I had the same problem. The charging power in amps from 90 to 100%. was too high. 40A is too much. I now switch on a load and reduce to max 10A then it goes on. From 95% SOC only 5A at 100% only 1A then finish switch off. I have watched my Tesla Model S loading from 90 % is slowly reduced to 1 A at 100% SOC
