question

maxtosea avatar image
maxtosea asked

What's a better BMS?

Right now I'm using the V.E Bus BMS along with Orion DC-DC 30amp charger everything is working fine but I have no control over the BMS.

I've recently heard about the

Victron Energy BMS210055000 Smart BMS 12/200

And was wondering if I should swap it

What would be my benefits by doing so?

Will I be able to use it with my alternator and get 100amps out of it?

Sorry for the newb questions

BMS
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
nickdb avatar image
nickdb answered ·

Unless you are building a DIY battery, a BMS provides no control. It is configured by the battery manufacturer.

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

pwfarnell avatar image
pwfarnell answered ·

I would go to the product page at

https://www.victronenergy.com/battery-management-systems/smart-bms-current-limiter

And download the BMS Overview document which covers the differences between the various units. I would then download both product manuals and example schematics as these will give you a lot of answers.

The CL BMS will only give you 100A if you have an alternator that will deliver 100A or more continuously at 14.4 or 14.5V. It does not have a boost function like the Orion if your alternator is low voltage.

I do not believe that the CL BMS has any more settings available than the VE Bus BMS and the CL BMS does not control a VE Bus inverter like a Multiplus. The manuals are your best source of information here.

3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

maxtosea avatar image maxtosea commented ·

My alternator s are 115amp each. So if I get the BMS 200 amp will I be able to put 200amp back into the batteries?

Also the smart BMS has Bluetooth wouldn't that allow me to see the inverter and the BMS?

0 Likes 0 ·
pwfarnell avatar image pwfarnell maxtosea commented ·
The Smart BMS 12/200 has an alternator current limit of 100A per the datasheet, again, you should download and read all the info. The Smart BMS has Bluetooth for you to monitor and set up the BMS but again, the settings are limited, look in the manual. The Bluetooth does not communicate between the BMS and inverter, so the BMS does not directly control the inverter. If it is a small inverter, less than 2000VA you can connect it to the system port, a larger inverter will need to be controlled by the ATC and ATD ports.
-1 Like -1 ·
Show more comments