question

oli-clarke avatar image
oli-clarke asked

MPPT not getting into absorb, only bulk

bulk-then-drop.pngscreenshot-20240521-105312.pngI have a MPPT 75/15 connecting a 110Ah Leisure Plus battery and 160W panel.

All was working well, until the last week, whereby I seem to get a short period of bulk charge, which then cuts out and drops to charger off - where I would normally see abs/float.

Any ideas why this might be? I don't think I have changed any settings, the wiring appears ok.

MPPT Controllers
bulk-then-drop.png (58.1 KiB)
screenshot-20240521-105312.png (66.9 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
klim8skeptic avatar image
klim8skeptic answered ·

@Oli Clarke There is a firmware update available.

Download Victron Connect 6.10beta4 and apply mppt firmware v1.64.


4 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

klim8skeptic avatar image klim8skeptic ♦ commented ·

@Oli Clarke if that fails, Check your solar panels.


0 Likes 0 ·
oli-clarke avatar image oli-clarke klim8skeptic ♦ commented ·

I don't seem to be able to get the APK to install - I'm on a Pixel 6, so the ARM format should work. I enabled allow unknown source, so strange.


Is there an alternative way to get the firmware onto the controller?

0 Likes 0 ·
oli-clarke avatar image oli-clarke oli-clarke commented ·

never mind - had to uninstall the old app first. I've updated the app and firmware now. No immediate change, but will monitor and see what occurs

0 Likes 0 ·
Show more comments