question

ken-wagner avatar image
ken-wagner asked

Parallel Mulitplus II units show 0 amps input

I have two Multiplus II units wired in parallel, and the system worked fine until performing a remote firmware upgrade to version 510. After the update when running with generator AC input, I no longer see any current values on the L1 or L2 input. We see a input wattage (not sure how) and correct voltage. The output current readings show a negative value and the units no longer support the power assist function. AC power load values decrease to incorrect values while using the generator input. While operating in inverter mode all values are correctly displayed.

multipluss ii
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

3 Answers
ken-wagner avatar image
ken-wagner answered ·

screenshot-2024-05-14-75717-pm.png

screenshot-2024-05-14-75741-pm.png

Note Input power with 0 current, output current is negative value


screenshot-2024-05-14-75717-pm.png (63.3 KiB)
screenshot-2024-05-14-75741-pm.png (62.1 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Kevin Windrem avatar image
Kevin Windrem answered ·

You say these units are connected in parallel but the screen shots indicate a 2-phase configuration. That could be causing all sorts of problems

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

ken-wagner avatar image
ken-wagner answered ·

Hi Kevin, The L2 was added in a firmware update in the Multiplus II / Cerbo Gx. The Multiplus II has two input lines, however, when in inverter mode, it ties L1 to L2 for split phase operation as in a RV application. Another post help us solve this problem, it is a faulty external current sense connector on the Multiplus units. It would fail to make the connection internally that told the circuit to make use of the internal current sense device. The fix was to simply plug and unplug an audio plug in and out several times which caused it to make the necessary connection again.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Additional resources still need to be added for this topic