This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi
I have installed a victron 15kw quattro with 6x us3000C pylontech batteries and when it goes to 100% it gives out a high voltage alarm and internal failure error and trips the whole system. Please let me know how to fix this I have tried everything
The alarm is coming from the battery monitor (should be the Pylontech) not from the Quattro.
Under advanced you can enable diagrams for the battery voltage/current, min/max cell voltage and charge/discharge limits from the battery.
If it is the very first time charging to 100% you should do that with a small current to give the battery time to balance the cells.
Did you install the system according to the instructions?:
https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom
HI Mathias,
Yes I followed all the instructions, but it is still pumping up the voltage to 53V which shuts down the battery bms and cause the victron to shut down, I have limited the voltage to 52v on DVCC and tried doing it on VECONFIG aswell but no Luck, any comment on how to fix this?
