question

Val Vechnyak avatar image
Val Vechnyak asked

DC/DC negative reads 11v positive

I've identified a strange problem and possibly my NON-isolated dc/dc tr orion has gone bad? when battery 1 is connected to 'IN', the voltmeter is showing about 11v between boat negative and the negative/common (middle connector) on the controller. could anyone try to explain why is this happening?


The other side of the voltmeter is connected to the negative buss on the boat.


20240504-122751.jpg

20240504-122753.jpg

orion dc-dc
20240504-122751.jpg (96.9 KiB)
20240504-122753.jpg (110.1 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
pwfarnell avatar image
pwfarnell answered ·

But you have not connected the negative side to the battery, just the positive, so there is nothing to drain the positive voltage, the positive voltage goes into the unit but can not come out so the whole unit gets to close to the supply voltage.

Nothing wrong here.

5 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Val Vechnyak avatar image Val Vechnyak commented ·

That's the point. The battery negative already connected to the common buss. why would positive voltage read on negative connection of the Orion? Is my controller bad?

0 Likes 0 ·
pwfarnell avatar image pwfarnell Val Vechnyak commented ·
You are not understanding, you MUST connect the negative port of the Orion to the common negative bus bar. Current is trying to flow through the Orion from the positive input to th negative terminal and back to the battery. Because you have not connected the negative to the battery, the voltage builds up on the negative terminal because it has no where to go. Consider the inside of the Orion to be a resistor from positive terminal to negative terminal, if you only connect the 12V positive to one side of the resistor the other side will read 12V also. The Orion can not generate the same voltage as the battery when only connected.
0 Likes 0 ·
Show more comments
jwijnstra avatar image
jwijnstra answered ·

Did you somehow solve this? I've got the same issue here. The ECU of the engine is giving issues, the only thing we could find is this so I'm hoping to sort it out by solving this issue.

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

kevgermany avatar image kevgermany ♦♦ commented ·
There should be direct negative connections between the different batteries. Otherwise each section of the system can run at a different voltage when compared to the other.

The negative of the Orion should be connected direct to the common negative.


0 Likes 0 ·

Related Resources

Victron DC to DC Converters Product Range

__________