Hello..currently on the road without land connection... I am looking to install my raspberry pi/Victron during my vacation
Is there a way to do that with my « hotspot « from my iPhone.. laptop
Tks
This question was
closed
by
fenix for the following reason: The question is answered, right answer was accepted
asked
How to connect to VRM portal with mobile phone hot spot
Hi Fenix. Yes, it should be possible to do that if your lappy can access the web via your 'hotspot'.
For a router, just use an ethernet cable from the lappy to your "RPi-GX", and 'share' the hotspot connection. If you need help doing that, ask again. Win call it ICS, and I believe Apple do it too. Google can help with that too.
You may find your LAN address changes occasionally if you shut the lappy down, but VRM will catch up once you start it again. Easy to ask VRM what the new LAN address is, so you can locally access the RPi without web delays.
John, I don't think it would work as above. I am pretty sure if you did want to connect the Pi direct to the Laptop via it's ethernet port (if it had one - many don't anymore), you would need to get a crossover cable.
When you say "install my Raspberry Pi during my vacation", is this a brand new installation? I am asking this as when you first setup the Pi, you need a wired ethernet connection to be able to get to the Remote Console via a browser to then configure the Wifi.
This is what I would do myself ....
1) Buy one of these - GL.iNet GL-MT300N-V2 Mini Travel Router (This is a link to Amazon UK. I am sure the same device is available in other locations). This router is really nice and can also be powered using one of the Raspberry Pi's USB Ports and comes with all cables needed.
2) Configure the Router as a Wi-Fi Extender rather than a router. This will get your Pi it's IP Address and allow you to use your laptop, phone, tablet whatever to connect to it to configure via the Web Browser.
3) Set up the Pi WiFi with the Hotspots you have available. It will then connect automatically whenever it sees one of the active hotspots and upload data to the internet.
You could remove the Mini Router after you are setup but it is easier if you leave it plugged in as it will act as an Intranet hub as well as an extender and you can connect to the Pi via a web browser at any time without internet or cable (just point the laptop or phone Wifi to the Mini Router as well).
In reality, you can configure the Pi and the Mini-Router setup above probably faster than it took me to type this!
I was able to get the up adresse :-)
Now connected to the portal
