This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
In the IOS Widget, the temperature is correct, but on the dashboard, it recalculates after page is completely loaded, look at the Residence temp in the recorded clip.
They are not calculated, just reported/displayed.
Is the residence temperature sensor a Bluetooth one?
Yes they are Bluetooth.
The strange thing is that the IOS widget reports the correct temperature, but the VRM webpage changes the temperature in front of my eyes, when the page is completely loaded. Just as the videoclip shows. It first shows the correct one, 6.3, then changes to 6.8 and then changes to 6.4, and this behavior is only shown on the first temperature value, not the other ones, while the IOS widget shows the correct value all the time.
So wont be as realtime as other figures need to be. Remember it has to stream from your install to the vrm then back to you. So there are quite a few considerations here.
IOS widget is continually pulling/refreshing the values when it decides to check. It would appear that is a static element on VRM, since the page isn't being reloaded it isn't updating.
Have you tried with a different browser or mobile app and with another device?
I don't have any issues but then, I have only 2 temperature probes which are hardwired.
In my experience, the widget figures are never the latest because they come from VRM but they don't update as frequently.
In turn, VRM never generates its own figures. It reports what it gets from the GX console. Of course, there can be faults in how the data is rendered.
For an accurate comparison, don't use the widget but use the remote console.
Rule out browser or device issues.
Fideri
So what I did to remove the browser from the equation was the following:
So there is something in the VRM portal that causes the temperature to be displayed incorrectly.
