question

martin-modr avatar image
martin-modr asked

REMOTE CONSOLE - Failed to connect. How to enable Remote Console without acces to Remote Console?

I updated the FW in Cerbo from 3.10 to 3.30.

During this, my internet connection dropped, but then it finished, it didn't report any errors.
In the list on the Gateway I see:
Firmware version: v3.30
Remote Console on VRM: Enabled and up
Two way communication: Enabled
Remote support: Enabled and online - 84.22..........
I will get to NR, programming and Dashboard.

BUT!

I can't get into the Remote Console!
I try it like this:
1) via VRM - it doesn't work
2) direct login via LAN address 192.168.0.XXX - not possible
3) direct login to WIFI Cerbo GX, that's a different address, but again it doesn't work
4) I also tried the VictronConnect application with wifi, it's the same there
5) if I log in to VictronConnect via Bluetooth, I can change some things in the network settings there, but I can't go to the Remote Console from thereI probably need to get to the Remote Console to allow LAN connections there, but I can't log in there.

I didn't change any settings, just updated the FW.

No idea what to do with it?

I saw this topic here but no solution.

Thans!rc.png

cerbo gxfirmware updateremote console
rc.png (7.5 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
martin-modr avatar image
martin-modr answered ·

SOLVED using HDMI monitor, USB mouse and USB keyboard to Cerbo GX. Then restart from Cerbo GX.

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

nickdb avatar image nickdb ♦♦ commented ·
When in doubt, just pull the plug, That's the tried and tested, old-school approach.
0 Likes 0 ·