question

seltsam avatar image
seltsam asked

Low voltage readings on MPPT 75/15

I was wondering why my battery was empty and checked the setup again. Turns out that the charger doesn't seem to show and handle the wattage that is actally put out by the panels:


Charger display: 16v 1.8A

Multimeter readings: 30v 3.4A (measured on the disconnected panel cables)


How is this possible? (The battery is not full, and also pluging in a laptop or something doesn't increase the reading.)


Could this have to do with a firmware update lately? If yes, how can I roll back the firmware?


Thank you

MPPT Controllers
5 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

seltsam avatar image seltsam commented ·

Here you find pictures from my meassurements vs the reading in the app. Should I refund the Charger?


0 Likes 0 ·
46473e71-7a4d-4b2a-aa3a-3a3d72036e8d.jpg (445.7 KiB)
32f4fee3-6a00-4ef5-90ae-ffa229b749ee.jpg (468.6 KiB)
e9bd30a6-8d6d-4592-a9df-ed29ccf7457b.jpg (66.1 KiB)
JohnC avatar image JohnC ♦ seltsam commented ·

What you appear to be doing there is measuring the open circuit V with no current flow (Voc), then the current in short circuit conditions (Isc). Your panel should have it's rated specs for those on it's label.

Meaningless unless under production conditions, which are neither of those. They become Vmp and Imp, and multiplied together become W.

You could send your mppt back if you want, but you may well have a sick panel. I'd be looking thereabouts first.

0 Likes 0 ·
seltsam avatar image seltsam JohnC ♦ commented ·

Hi, Thank you! How can I measure the panels to get the actual output to validate the panels are OK?

0 Likes 0 ·
Show more comments
1 Answer
Robert avatar image
Robert answered ·

Hello,

what size panels? how many? parallel? series? Do you have a screenshot of the 16V 1.8A reading? How are you getting 3.4A on disconnected panel cables? What battery setup are you using? Plugging in a laptop (where?) doesn't increase what reading?

Robert

MI

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

seltsam avatar image seltsam commented ·

Hi Robert,

please keep in Mind that the Panel-Setup worked as expected previously.

Panel Size shouldn't be an issue, since I didn't change anything on my setup.


> What size panels?
100W

> how many?

2

> parallel? / series?

Readings are off for both, tried it.

> Do you have a screenshot of the 16V 1.8A reading?

No.

> How are you getting 3.4A on disconnected panel cables?

1. Remove the panel-cables from the PV-connections on the charger

2. Put your volt-meter to the cables, plus and minux

3. Read what the volt-meter shows

> What battery setup are you using?

90Ah lead

> Plugging in a laptop (where?) doesn't increase what reading?

Connect my laptop-charger to the controller output to have a source that pulls power (to make sure its not the batteries fault).


0 Likes 0 ·