Hi there,
I cannot figure out why I'm getting overload alarms at just over 7.5kw load on any phase (3 phase). I do connect to the grid during off-peak hours with no alarms, this only happens when I'm off grid (relays open).
Can someone advise me on why this happening and a solution for this. Basically the this is trigged from a hot tub running.
Here is my setup:
- 3x MP2 10kva on v506
- 16x Pylontech batteries US5000 connected in banks of 2x
- Batteries never go above 25c
- Environment where the equipment is at 20c
- Running at 240v at 50hz