Using the MultiPlus on a small scale Solar installation.
Configured in inverter mode only - operating with 12V (nominal) battery input and AC output to run LED lighting.
It's been operating for 4 months without problem.
The unit then failed. There isn't any LED indication or AC output.
The unit has been left switched off for 30 minutes in an attempt to 'reset' it but is still unresponsive.
The internal fuse is intact and the manual doesn't suggest there is a user replaceable fuse in the enclosure.
I am very disappointed with this early failure. And espectially given the unit isn't operating anywhere close to it's rated maximum power output or on a continuous basis.
Are there any more diagnostic steps that can be run or is this a write-off of almost new equipment?