question

@stefanm

What are the components of the system you are planning to install it in? Will the battery have control over that system?

The manual recommends each battery be charged as individuals before connecting in series, so technically any charger programmed correctly would work. I am going to say there is more emphasis on the initial individual charge (and balancing) of the units. We can help more if we know what else is going to be connected to them.

You could always do a cheeky ask of the dealer to do the initial charge for you. They most likely have the correct equipment.

Hi, thanks. The battery manual says “Always use a BMS-controlled charger when individually charging lithium batteries.” I would like to follow this recommendation. Also, it will not be possible for me to continually monitor the charging. I will have a Multiplus-II 48/5000 as my inverter/charger and a SmartSolar MPPT charge controller.

I am also in this same boat. @stefanm did you find a solution to this? I definitely do not want to spend another 400 dollars on something I will use one time.

I think I'd put a meter on them and if they're at the same voltage, just install them and charge them using the same equipment that will be charging them for the next however many years.

Surely the BMS you are installing should ensure that any balancing needed takes place?

I have heard from different suppliers:

-don't worry about it, you can use an IP65 charger and leave it overnight (not what the manual says)

-you can set up a BMS-controlled charging system using an IP67 charger, a BMS, and a Battery Protect (not clear to me how)

-take them to a local dealer and ask them to charge the batteries

-use an IP43 charger and SmallBMS (this is the expensive option that is specifically mentioned in the Victron professional video on the batteries). Connect the BMS (using the charge disconnect output) to the charger with a length of 16 or 20 awg wire, and power the BMS with a ve.can power cable with the end cut off (Victron does not make a power cable specifically for the SmallBMS).

This is only what I've heard. I am hoping to confirm some of this today, and will update if I learn anything. Good luck!