This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
We have a catamaran that we are fitting 2 x WS500s to, as well as a Cerbo. A shunt and BMV are already installed. The shunt/BMV will be connected to the Cerbo via VE Direct and the WS500's will be connected via VE CAN.
As we would like to use the shunt connection on the WS500's to monitor alternator output, will battery data, such as temp, voltage and current be passed to the W500s via the VE Can network? Or do we need to connect one of the WS500s to the shunt/battery bank?
If you have WS500 firmware version 2.5.1 you can connect the WS500 to the Cerbo GX via VE Can (note cross over cable required) and you should be able to tell it to get battery current and voltage from the shunt. See the WS500 communication and configuration guide page 69, Victron shunt is option 18 for the Enable_alt_can setting. You could also use the Nmea_rat option and get the Cerbo to output NMEA2000. I have my WS500 ready to install but can not confirm this works exactly as advertised but hoping it is the case.
