Hello, I'm new to this forum. I have installed for a client a multiplus2 10kW and the virtual switch isn´t behaiving correctly. Either i´m doing something wrong or the multiplus is faulty. the multplus is connected to the mains electricity, 48V lithium batteries and a Cerbo GX. Using Victron Configure i´ve set the VS ON after 5 seconds at 48.8V and VS OFF atfter 5 seconds at 50V. The mains is not to charge the batteries, it is only to power loads when the state of charge is low. The batteries are only charged from the solar array. What is happenning is that the VS only comes on at 48.35V, and off again a few seconds later at about 48.6V. The multiplus is ignoring the voltage settings that i configured. Does anyone know what I´m doing wrong, or thionk that the multiplus is faulty? Help with this would be greatly appreciated.