This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Can please someone give me an answer why no solid state relays work on load output of victron smartsolar 100/50.
I have done everything like in description.<TX cable ,Right configuration,the ssr works from 4 to 32 Volts dc.
Multimeter says load output of the victron has about 5 to 7 Volts. But no working.
Must it be a special ssr? Or is the smartsolar damaged?
"Must it be a special ssr?"
What model SSR do you have? Which model of TX cable?
Picture/diagram of wiring please.
I seem to recall the SSRs don't like reverse bios. I was using two on a BMS (one load side, one charge side) I think the problem was that on the charge side (depending on wiring) the SSR output terminals would go reverse current when charging stops (ie when the sun goes down). Could this be your problem?
