This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello Everyone,
I have a problem with the VRM, when I am being on the dashboard, the message below pops up.
The message is: "Installation too busy, realtime data link disabled".
Could anyone has faced the same problem advice the solution?
Thanks in advance!
Hi @tareq,
I believe this warning occurs when the CPU of the GX device is under too much load. I'll confirm it with the VRM team and also see if that message can be changed to make it clearer.
The realtime feature of VRM consumes quite a bit of CPU resources, and temporarily pausing it automatically is an easy solution when necessary. While the feature is handy, it's a relatively low priority compared to other functions of the GX.
It shouldn't normally occur on smaller systems with default parameters. However the bigger the system, the more customisations (especially Node RED), and the older the GX hardware (CCGX -> Venus GX -> Cerbo GX -> Ekrano GX) the more likely it is.
So, what seems to be the solution for this matter?
Your soonest answer will be appreciated.
I have been having the same issue, I have created dbus round trip time widget.
Is that excessive ?
Yes it is,
Here is mine for comparison - your is two orders of magnitude higher.
The CPU of your GX is overloaded.
Would a software update fix the overload ? V3.10 installed.
Current System: Off Grid
1 x 15000w Quattro
1 x 8.2 Primo Fronius
1 x 6.0 Gen 24 Fronius
1 x 150/70 Mppt
CCGX
32kwh BYD LV storage
I do have an Ipad on all the time in the house displaying VRM data of my installation.
