Non ESS - AC Loads reflect load from Grid not AC Loads downstream from Multiplus

With a grid meter upstream of Multiplus without ESS enabled , is it possible to have the AC Load widget only reflect the AC output load of the Multiplus? The scenario here is that I have a motorhome with the Air Conditioner running that is not behind the Multiplus.

Thanks

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

gharshaw commented · Nov 22, 2023 at 11:26 PM

Loving the new GUi-V2 but same issue for me. AC Loads does not reflect the Multiplus AC Out when not in ESS mode

0 ·

1700695478880.png (358.7 KiB)

1700695501975.png (73.4 KiB)

1700695523329.png (138.3 KiB)

nickdb ♦♦ commented · Nov 23, 2023 at 04:53 AM

What type have you configured the grid meter as? It should be configured as a grid meter, not as AC load.

0 ·

Show more comments

gharshaw commented · Nov 24, 2023 at 07:07 PM

@mvader (Victron Energy) @Guy Stewart (Victron Community Manager)

May I get your thoughts on this issue for me. In my research I see that AC Loads widget is based on system consumption. Since I Prefer AC Loads to be about the AC output of the Multiplus, would this change be a DIY GUI modification change?

I appreciate any input you might have.

Thanks

0 ·

Show more comments

morganb commented · Jun 10 at 10:00 AM

I'm looking at the same thing right now on a new install, I'm actually ok with where the AC loads are showing but a question is with the energy meter, where have you clamped the 2 loads as I see you have 2 figures, have you got main line an non inverted line camped, maybe you could do me a sketch??

0 ·