question

Trevin Corkery avatar image
Trevin Corkery asked

BMV prematurely resets SOC to 100%

I have a 12v lead acid battery that I drained to 50% SOC but when the charge controller starts charging the battery it will increase the SOC normally until the charger makes the battery reach 13.20v while current is going into it, which makes the SOC jump to 100%. I know the battery isn't 100% SOC because its still undergoing the bulk charge and hasn't touched absorption/float as it normally does.


I assumed since the BMV does calculations with amperage for discharging to determine that actual SOC instead of relying on voltage, that it would do the same with charging.

Also I could have the BMV configured incorrectly so if there is something I should change in the settings let me know.

BMV Battery Monitor
2 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Mark avatar image Mark ♦♦ commented ·

To assist further could you provide some screen images of you current:

- Charger settings (I assume MPPT)

- BMV settings

- Battery capacity

- Confirmation that it is a premature synchronization that causes the SOC% to jump to 100% at one point during recharge, or if this happens gradually during recharge.



0 Likes 0 ·
Show more comments
1 Answer
Mark avatar image
Mark answered ·

You new settings look like a good start.

Providing that the battery does get fully recharged and the charge current drops off sufficiently at the end of absorption phase, you could go even lower with the tail current %, say ~2 or 2.5%.

You just need to be careful not to make the sync criteria too strict or you will have the opposite problem and it won't ever sync.

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.