Hello,
I need help to establish a low battery SOC shut down of the Phoenix Inverter.
Tried several things over the VE configure3 software:
1. simple set up of shut down by marking the checkbox "shut down on SOC" with setup of min / max values for SOC
2. Also - setup of relay conditions via VE configure 3 software with the assistants. 2 rules successfully set up, but the relais doesn't switch. (virtual switch is off)
I am doubting wether I look at the right relay: mainboard, upper right - see photo.
Questions:
1. Can somebody give assistence to switch off my Phoenix by pure software - why is the inverter not doing what is suggested by the VE configure 3 software? (down- and uploading the configure file went well with success)
2. See the photo attached: is this the programmable relay of the Phoenix 48 20 5000 ?
3. if both is not possible - How can I use the cerbo' relays instead of the phoenix relay to program SOC conditions? The Cerbo webserver doesn't offer settings for programing the relays.
4. What do I need to do to access Node Red on the Cerbo? I read posts about this subject, but I am not familiar with this way.
Any help is appreciated.
Best regards