This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
im using a pi to run venus os. i have my relay board connected. im using https://github.com/kwindrem/RpiGpioSetup to give a few more options. relays 1 - 4 are on when the relay switch in venus says its off. how can i set it so the relay position is swapped so when my relay switch is on the relay is on?
I would ask in the github but i dont see a discussion tab
What you are trying to do has been discussed before but may not be possible. Inverting the state of the relay control probably requires a DT overlay and that is certainly possible. However, during boot, the relays will all close until the DT overlay loads. Depending on what is connected to the relays this could be highly undesirable.
