question

Mark avatar image
Mark asked

Rpi gpio change to pull to ground

Hi All

Is it possible to change the gpio pins to pull to ground when switching relay on rather than 3.3v?

I've read that the rpi can do it but not sure if you change this in venus? I've had a nosey in gpio settings but nothing obvious jumps out at me?

Does anyone know where or how to change this?

I have managed to get 8 relays active with the switches in venus, but I bought a relay baord the ground switches not 3.3v hope that makes sense.

Thanks

Mark

Venus OSRaspberry PiRelay
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

0 Answers

Related Resources

Additional resources still need to be added for this topic

Raspberry Pi running Victron’s Venus firmware - Blog Post

Venus OS Large image: Signal K and Node-RED - Install

raspberrypi install venus image


Additional resources still need to be added for this topic

Victron Venus OS Open Source intro page

Venus OS GitHub (please do not post to this)