question

s1277 avatar image
s1277 asked

Using Temp Sensor non Battery Question

Using the ASS000001000 Temp. Sensor for Quattro, MulitPlus & GX Device with my cerbo monitoring temp of my HW compartment, black water tank compartment, under my sink and main cabin.

Can I just have the remote end exposed to air or does it need to be attached to something metal or plastic to get correct data ?

I have VRM and Cerbo set to F do I still need to set temp sensors with an offset? seems to always be in the 50 f range

how far can I extend the sensor?

On Cerbo does red face out and black in markings are unclear?

How do I get sensors to show temps in the tanks column on the Mobile Overview page

Temperature Sensor
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
chrichri avatar image
chrichri answered ·

Hi,

The metallic end does not need any contact.

50F seems ok. =10°C

Temp in Tank view is not implemented.

In VRM Portal view you will see it on right side.

I would not too much extend. Use the ruuvi sensor for humidity and temp if you would like to be cable free.


3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

s1277 avatar image s1277 commented ·

I do not think they are accurate or need an offset in my rv no heat and show really warm


1698273843480.png


compared to my bluetooth devices I m replacing


1698274069213.png

0 Likes 0 ·
1698273843480.png (24.8 KiB)
1698274069213.png (891.2 KiB)
Show more comments

Related Resources

Victron temperature sensor disambiguation table - which product supports which sensor