I have a Setup with 2 Smart MPPT 100/20 loading the same battery bank. Works like charm.
One MPPT is connected to the virual Load Outlput Cable of a Smart Battery Protect, running a Load at Nighttime. Works nice, too.
My Question: Is it possible to use a 2nd Output Cable from the 2nd MPPT, and switch the same Battery Protect based on the Batterie Voltage ( when close to Full Charge ) .
2 virtual Load Outputs connected to one Smart Battery Protect
I just want to prevent a waste of energy when the Batterys are fully charged early ...
Best Regards,
Kai
