This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
While trying to set up a Raspi4 and Expander Pi board for analog level sensors I tried to check which services were running. Neither systemct1 or services seem to exist as a command in Venus OS3 .2 . Is there a way to install these commands or is there another way to check which services are running?
Venus OS does not use systemd to run services. Rather it uses a system called daemontools:
https://cr.yp.to/daemontools.html
You can use svstat /service/* to get the status of all services running (or not) on the system.
https://github.com/victronenergy/venus/wiki/howto-add-a-driver-to-Venus
This gives a good method too.
