question

annewilson576 avatar image
annewilson576 asked

Deleting / removing 3 phase configuration

Hi everyone,

We have 3 x Multiplus configured for 3 phase use. However, I now need to power them up individually for testing purposes. I have run VE Bus, and tried many combinations, but am unable to remove/overwrite the 3 phase programming so that they operate individually. I try to drag each unit into L1 and set to 1phase, but the option to send config is un-selectable. Perhaps I will need to factory reset?

Cheers for any help,

Anne

3 phaseVE.Bus
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

annewilson576 avatar image annewilson576 commented ·

Nevermind folks, i worked it out, needed to set it to Single phase 1 input and then it was able to send the config.

0 Likes 0 ·
1 Answer
annewilson576 avatar image
annewilson576 answered ·

Nevermind folks, i worked it out, needed to set it to Single phase 1 input and then it was able to send the config.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.