Just got this 12v wind turbine as a gift (https://www.yumpu.com/en/document/read/11133725/air-403-land-manual-southwest-windpower) , bearings are completely cactus but the rest is working fine. I'm running a full off grid easysolar 24/3000/70 system with 6 250w panels and 8 190ah agm batteries in series parallel 24v connected via a lynx power in (modified with fuses). The turbine is 12v and has a regulator integrated from what I have understood. Wondering if I could hook it up to a step up 12 to 24 and after into a victron mppt before going into the bus bar so I can monitor it in vrm? Will the regulators conflict? Or should I use only a shunt in dc monitor mode? Also will the stepup 12 to 24 be ok with the rest of my system, providing matches the potential max amps of turbine? Thanks for your suggestions
