This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have had a Multigrid 48V 3kVa working flawlessly in an ESS system with a BYD battery for about 12 months.
A couple of days ago there was a power outage that lasted for over 6 hours.
The system stayed up during that time. When the mains grid power came back. The system switched over from inverter mode to pass through mode and stopped the discharging of the battery.
Why might this be?
Reviewing the device list for the system on VRM, there appears to be some issue with the grid meter. While it is still reporting, it is not as frequent as is required.
As the system is set to work with a grid meter. If the setting in VENUS is set to enable grid meter, and no meter is available, or it is not functioning correctly, this can lead to a pass-through state.
Disabling the grid meter setting immediately re-activated the inverter function for the critical loads. Though now the additional AC solar and large loads that were on the grid meter and not used in the ESS.
For full functionality, the grid meter will need to be checked for connection issues, and possibly replaced if found to be faulty.
UPDATE - The RS485 cable to Grid meter was very long. The length was reduced and the meter re-appeared and began to report properly again.
Hey all, see also ESS FAQ, Q4. Thats really the place for solving passthrough in an ESS system:
https://www.victronenergy.com/media/pg/Energy_Storage_System/en/faq.html
Hi, i have the same problem since yesterday mid day on a clients site. its stuck in passthrough, all the coms from bms and gridd meter seems fine and refreshes as it must.
I am going reboot this morning and see if it solves it.
I did also open a separate thread yesterday already.
Dear friends,
I am sorry for not opening a new thread, but I have experienced a similar problem with a customer's system. Multiplus and Fronius inverters are connected in parallel to the grid.
My customer told me he noticed 2 power outages. I think the problem comes from the BMV monitor, but a problem from the grid meter has more sense. I attached pictures from the VRM portal:
The previous night of a power outage, I found some error from the BMV monitor:
And this 25th april when I enter in the VRM portal, It showed an error message in a red window, it says something like "a device is trying to send data". I had to restore the token authorization in order to solve the problem. But before restoring the token, I noticed this:
I called my Victron Seller in order to request them to write to level3support mail. But I have no news and no technical explanations.
Please, could you help me? If you need more information, please let me know.
Best regards,
Daniel.
Lithium battery? I think the system doesn't see the BMS --> safety function is pass-through
Check the battery / cabling
