Hello
My 48V battery bank doesn't seem to be go into a float/rest voltage after reaching 56V as configured by the MPPT controller.
The bank will continue to sit at 56.0V all day. Little worried as bank does not get to rest after full charge.
My system configuration-
Victron Cerbo GX
Victron MPPT 250/85 VE/MC4
Victron Mulitplus-II 48/5000
2 x 48V 100AH Lithium batteries (Total ~20KWH)
DVCC Enabled
Shared Voltage Sense - Enabled
Shared Current Sense - Enabled
The Charge Voltage Limit (CVL) setting that is hard coded for the batteries - visible from BMS Cerbo/Touch screen is 56.0V
Picture of Victron MPPT Configuration
Any advice/suggestions appreciated