question

Sebastian avatar image
Sebastian asked

Torque of the clamps / screw connections

Would it be possible to print the torques of the terminals on the Victron Products?
There are some places where I would find it handy to print them out (for example):

  • Multi Plus / MPPT RS: on the PCB next to the therminal / bolt, or in the cover next to the schematic.
  • Smart Shunt: next to the top printing (Battery minus / Load minus), or on the lable
  • Lynx Distributor: under the Victron laser marking on the positive bolt holder.


That would be helpful. Especially since, for example, the torques of the M8 bolts of the RS450 (14 Nm) and MultiPlus (12 Nm) are different.

@Guy Stewart (Victron Community Manager)
Also, I can't find the torque of the PV terminals of the RS450 in the manual.

Multiplus-IISmartShuntmppt rs
8 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra avatar image Alexandra ♦ commented ·
PV terminals is mentioned in the printed manual


3.5 Cable connection sequence


third:.... 2,4 nm


I think the other side of the two edged sword to the handy dandy printing of the torque is that even less people will read the manual when installing.


0 Likes 0 ·
Show more comments
1 Answer
nesswill avatar image
nesswill answered ·

There are various guides available here is a couple I use... (but if stated by the manufacture this value should always be used) but as with anything common sense is a good tool when doing anything.

TorqueValueGuide.doc (norbar.com)

TR knowledge base | Socket Screws tightening torques (trfastenings.com)

Dave.

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.