HI,
I have purchased a BatteryProtect 200, and the unit differs from the manual. I would like to use the Load Disconnect output from a BMS to control when the BatteryProtect cuts power.
I have programmed the BatteryProtect to mode C, but the unit has remote pins "H" and "L". I cannot find these in the manual, and the order of the pins for Alarm/GND/Prog on the unit is not the same as in the manual either. I've taken the latest PDF from the web site, that was no help either.
Which Remote pin shall the BMS Load Disconnect output go to?
Best Regards,
/Sverre Eplov