question

tverweij avatar image
tverweij asked

SmartSolar Firmware 3.14 does not compensate for temperature

I just upgraded to 3.14 (SmartSolar 250/100). And after the upgrade, it started to do an absorption.

At this moment, it is 32 degrees celcius - just before the update (on 3.13), it was doing the absorption on 58.5 V, which is correct as I has set the absorption voltage to 59.2V and a temperature correction of -96 mV/C (59.2 - 7 x .096 = 58.5).

After the upgrade, it continued the absorption at 59.2V - the value I set for 25 degrees celcius, 0.7V too high for the current temperature.

So, it looks like the temperature correction is broken in this version.



firmware updatetemperature compensation
2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Thiemo van Engelen (Victron Energy staff) avatar image Thiemo van Engelen (Victron Energy staff) ♦ commented ·

Hi @tverweij

So after a few days, is this still not working?

Can you perhaps add some screen shots of VictronConnect of the main SmartSolar page and of the settings of the SmartSolar?

And do you also have the SmartSolar in a VE.Smart network with other products?

Kind regards,

Thiemo van Engelen

0 Likes 0 ·
Show more comments
1 Answer
Thiemo van Engelen (Victron Energy staff) avatar image
Thiemo van Engelen (Victron Energy staff) answered ·

Hi @tverweij

Normally, an MPPT takes a temperature reading of the internal sensor at the start of a charge cycle and uses that for the temperature compensation (when an MPPT does not receive a temperature from some other device). What could have happened here is that the internal temperature reading was not in a valid range because the MPPT was still quite hot from the charge cycle right before the update and thus discarded the temperature reading. It would then use the set voltages like it was 25 degrees.

Kind regards,

Thiemo van Engelen

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.