question

urbanr avatar image
urbanr asked

BM-712 shows 100% instead of real value 92%

img-7255.pngimg-7265.pngimg-7254.pngI have 2x 160Ah Sunlux Lithium batteries. My problem is that the BM-712 always shows 100% before it is fully charged compared to reality and the Sunlux app. What can be the problem? see my attached pictures.

BMV Battery Monitor
img-7255.png (152.5 KiB)
img-7265.png (149.0 KiB)
img-7254.png (254.8 KiB)
3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra avatar image Alexandra ♦ commented ·
@UrbanR

Your bmv is set up differently to the sunlux. The real question is the sunlus also accurate? Does it use a shunt to measure?

What i would suggest is that you set your charged voltage much higher, since it is a lithium battery. What is the bulk/absorption target for the battery? The charged voltage should be quite a bit above float level but not too close to the bulk voltage

0 Likes 0 ·
Show more comments
1 Answer
klim8skeptic avatar image
klim8skeptic answered ·

@UrbanR you could adjust the BMV setting "Charged Voltage" to 0.2 volt below your chargers bulk / absorp voltage.

1 comment
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

urbanr avatar image urbanr commented ·
I have tried it now, the bulk voltage is 13,8 so I changed the setting to 13,6 will see if it helps.
0 Likes 0 ·