VRM.jpgBattery.jpgI lost my BMS now twice.
1) i could recover the connection to the BMS , after SOC dropped below 50% ( SOC treshold was 50 % in VE.Bus of the Multiplus). Disconnected the Battery from the
2) Nextday , I lost Connection again , at 70% SOC, (but could not confirm this figure) Have not been able to recover connection.
BMS: Seplos 10E , Can:Victron, model 1101-SP75 , Software Ver 16.4
BMS worked fine untill lost connection. Checked BMS with Seplos tool. Nothing particular. Is working correctly
Have Re-installed Venus OS ver 3.0, Large, no Luck, no BMS detected.
In system Setup, only Lynx Shunt and Multiplus Visible.
Did anything change in the CAN protocol in Venus OS ?
Is there a setting in Venus OS i can alter or remove, so the Cerbo will re-search for the connected devices. ?
Can bus no errors! Cable replaced no difference.
Removed the Shunt cable , Nothing changed , reconnected, all data of battery popped-up as before .