This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have 2 MPPTs connected to a Rasp Venus and DVCC switched on, a LiFepo4 with DIYBMS connected with CAN, it is a island setup with a Phoenix Inverter.
If the DIYBMS reduce the current for balancing, the current depends on the consumers switched on.
I adjust in DIYBMS for example to 1.5A balancing current and sometimes the current is 3A or sometimes -1,5A...
Someone know this problem?
I have seen the charge and discharge during balancing with other battery types as well.
I dont know that is can be called a problem. Some batteries discharge a bit to keep the balance under control.
Also dont forget if the system is trying to compensate for other consumers then it must produce or stop producing for those, there is bound to be a bit of give and take into the battery, since it is the most ready source of power and dump source.
This is probably due to the minimum current setting possible for the Multiplus. Current step resolution is not very good, particularly at lower currents. MPPT trackers are much better at providing low controllable currents for balancing.
