This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
My Lynx Shunt 1000 has an orange blinking light (means firm ware failure). It’s plugged into Cerbo GX correctly cable and terminating plugs. Cerbo GX firm ware is up to date. Shunt is not showing in VRM devices. Not reading on Touch 70. 24v Muliplue II can see the voltage. But the shunt isn’t reading anything. I hear you can update directly connecting to Lynx shunt 1000 but can’t find any info. Anyone have any ideas what’s going on or how to resolve this?
Here’s the resolution https://youtu.be/IA25PQVAmaA?si=4Uaslk9z8dKTRFvC
Did connection worked earlier or is that new installation? Have you tested different cable? Or is Cerbo restarted?
It was working at first install then out of no where this issue started. Cerbo restarted, and updated firm ware
@SaltyTrips did you manage to get this sorted? I noticed today I had the same problem while it was working fine last week.
Just updated to firmware v3.12 on the Cerbo GX but had no effect. Also tried complete power down and power up but no change.
Running with Pylontec 3000C so arguably don’t need the Lynx Shunt but nice to have when expanding to multiple battery banks.
Hans D
