question

francoisbrink avatar image
francoisbrink asked

BMV 712 SOC % wrong

Good morning. I have a BMV 712 series. Trailer with 2x 105Ah Deep Cycle batteries. It is a new trailer and new equipment. The SOC% seems to be wrong. From Float (100% charge) when put to use the % goes down. The % goes to aroun 65% and then the batteries is 'flat' as the voltage has dropped too far. How do I ensure the SOC and state of charge is more true. I have already syncronized the SOC when in float. My current Setting

Battery Capacity - 210aH

Charged Voltage 13.2V

Dicahrge Floor 50%

Tail Current 4%

Charged Detection Time 3m

Peukert 1.25

Charged Efficiency Factor 95%

Currenth Threshold 0.10A

Time To go Averaging 3m

BMV Battery MonitorSOCvoltage
4 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

seb71 avatar image seb71 commented ·
What is the usual discharge current?

Higher current means larger battery voltage drop.

0 Likes 0 ·
francoisbrink avatar image francoisbrink seb71 commented ·
Where do I see this
0 Likes 0 ·
Show more comments
3 Answers
francoisbrink avatar image
francoisbrink answered ·

screenshot-20230624-222844-comvictronenergyvictron.jpg

This was 1hr before the batteries was 'flat' at 65% SOC


screenshot-20230624-222844-comvictronenergyvictron.jpg (334.3 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

francoisbrink avatar image
francoisbrink answered ·

Graph of SOC vs Voltagescreenshot-20230625-063622-comvictronenergyvictron.jpg


screenshot-20230625-063622-comvictronenergyvictron.jpg (263.1 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

pwfarnell avatar image
pwfarnell answered ·

You may not actually be fully charging your ba as the the BMV may synchronise to 100% before the batteries are full. The charged voltage is too low at 13.2V, it should be set about 0.1 to 0.2V below your charging voltage, which is typically 14.4V or thereabouts. If you do charge at 14.4V then set the charged voltage to 14.2V. The tail current could also be set lower, perhaps 2% or even lower, mine is at 0.8% with AGM batteries.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Additional resources still need to be added for this topic

Victron BMV battery monitors product page