This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
My Multiplus II is set to a charge current of 90A (3x 30A LioP4 Rich Solar Batteries)
My 150/60 MPPT is connected to 800w of panels. My max charge current on the MPPT is set to 50A. Should I raise this to 60A since my three batteries should be able to handle it?
Yes, you could raise the MPPT current. However with Lithium batteries, you should have a BMS (Not mentioned) and integrate this into the system with a Venus VE device that will enable dynamic current limiting. This will allow the BMS to control the charge current as the battery approaches full charge and needs to balance.
Hmm. Ok. Thank you. I only have a MPPT, CerboGX, Linx Distributor, Multiplus II and a SmartShunt 500a. Sorry for not being clear. In my title I was thinking the Smart Shunt did what you say hence I was confused when I see different settings in the different devices.
Then make sure that the SmartShunt is set as the Battery Monitor in Cerbo GX and enable DVCC etc. (read the Cerbo manual for details).
Also, unless you have a reason not to, use ESS (again read the ESS manual first).
