Hello,
I have the following equipment installed:
1 x Quattro 48/8000 230V
2 x MPPT Smart Charge Controllers 250/100 MC4
8 x Pylontech US2000B Batteries
1 x Venus GX
The batteries are connected to the Venus through one Can port using the VE Can Cable Type B and the dummy plug is inserted in the other port. However, the Venus isn't recognising the Pylontech, it isn't shown in either the device list for the installation (usually shown under battery monitor) or in the device list section of the remote console.
Can-bus profile is set to Can-Bus BMS (500 kbit/s) and DVCC is enabled. Venus is on firmware 2.31 and Quattro is on 459.
Battery monitor under System Setup is set to Automatic but it appears to have auto selected the Quattro on VE Bus and the BMS is set as Off and doesn't give me the option to change it.
Please help me to enable the Pylontech BMS to act as the battery monitor.
Thanks