This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi guys
Tried to get one of these before our big trip but no luck. So I’m thinking of making one.
I have some 1mm2 wire, and can crimp to fit inside the Cerbo connector box… guess the other ends just go onto a large lug?
I know I’m being fairly simple but anyone know if it’s more complicated than that? It’s an analogue input to the Cerbo; I’ve already connected my water tanks, all good just don’t want to damage anything?
Alex
The device is an LM335, connect the +ve and -ve wires to the correct terminals on the device, do not connect anything to the third adjustment terminal and it will work. I have 3 home brewed ones on my Cerbo GX.
I think you will find under the sleeving is a thermistor (or possibly a thermocouple) which is the component which actually measures the temperature, the lug is just to make good thermal contact.
and here is the data sheet.
I found a thermo couple in Riyadh.. I’ve connected it to the Cerbo and activated the ports. It’s working but reads 125 degree Celsius… it’s hot outside (currently 50) and inside the boot is 28, but seems to be no way of calibrating the temperature sensor I bought
Do I need to solder "plus" also to ring eyelet?
Actually I've done it exactly the way like described here. However, the cable with sensor isn't working on my Smart Shunt 500.
What I've done differently is that after soldering and putting isolation around, I've glued it into a M8 ring eyelet. I have connected "plus" only to LM335 and not to the ring eyelet. Is that maybe the fault as there is no power getting from battery pole via ring eyelet to cable and thus Shunt?
The information above is all to do with the Cerbo GX / Multiplus temperature sensor which is isolated from the terminal lug.
The temperature sensor for the SmartShunt is different to the one for the Cerbo GX / Multiplus, they are not interchangeable.
The temperature sensor for the SmartShunt has 2 functions, the terminal is connected to the positive of the battery to provide the power to the SmartShunt and also the voltage sense. It also incorporates a temperature sensor which must somehow send the temperature signal down the negative cable to the SmartShunt. I have not seen any details of what is in the sensor, no idea if it is the LM335 or not.
The temperature sensor ASS000100000 for the smartshunt uses a NTC 150Kohm
And like @pwfarnell said it's a temperature sensor and also the positive connection to the smartshunt.
@Delta Victor do you have personal knowledge, besides referencing @WKirby‘s answer, that this sensor uses an NTC 150? There seems to be some confusion on this. Did you by any chance look inside one?
