question

Noel avatar image
Noel asked

PV not shown anymore on Cerbo GX (remote) screen!

Not sure if it was caused by the last update from the Cerbo GX (version 3.00), however my PV system is not shown anymore on the screen.

I've done several reboots of the system, but till now no luck.

1.jpg


2.jpg


3.jpg


VRM is showing this:

4.jpg


5.jpg


Anyone here who might know what is wrong?

cerbo gx
1.jpg (55.5 KiB)
2.jpg (49.8 KiB)
3.jpg (55.7 KiB)
4.jpg (46.8 KiB)
5.jpg (35.0 KiB)
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

matt1309 avatar image matt1309 commented ·

Is it because your multiplus is turned off/not connected?


I'm not too familiar with solar edge but (my only other guess) is does in PV inverter -> setup does it allow you to configure the position of the PV/where on the system it's connected ie ACIN vs ACOUT? Is that maybe not configured/reset through the update?

1 Like 1 ·
1 Answer
Noel avatar image
Noel answered ·

Thank you for your reply.

Guess what. After going back to the "old" firmware, all started working again as should.


6.jpg


7.jpg


6.jpg (55.4 KiB)
7.jpg (67.0 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.